دليل تقديم الطلب

Step 1: Prep the Skin

الخطوة ١: تحضير البشرة

• Clean: Wash the area with soap and water to remove natural oils or lotions.
• Dry: Pat the skin completely dry. The tattoo will not adhere to damp or oily skin.

Step 2: The "Sabr" Secret (Cut into Sections)

الخطوة ٢: سر "صبر" (التقطيع إلى أجزاء(

• Segment: For the best result and a seamless fit on the curves of your hand/fingers, cut the design into smaller, manageable sections.
• Trim: Carefully cut around the edges of each section to remove excess white paper.
• Peel: Remove the clear, protective plastic top sheet from the section you are applying.

Step 3: Position & Activate

الخطوة ٣: التثبيت والتفعيل

• Place: Lay the tattoo face down (design side against the skin) exactly where you want it. Once it is wet, it cannot be repositioned.
• Soak: Take a sponge, cloth, or paper towel and get it thoroughly wet.
• Press: Hold the wet cloth firmly against the back of the tattoo paper. Make sure the entire paper is saturated with water.
• Wait: Hold steady for 30 seconds. Do not let the paper slide.

Step 4: The Reveal & Set

الخطوة ٤: النتيجة النهائية والتجفيف

• Slide: Gently lift a corner to check the transfer. If it’s ready, slowly peel the paper away.
• Set: Let the tattoo air dry for at least 2 minutes. Avoid stretching, twisting, or moving the skin during this time to prevent the design from cracking.

Care & Safety

• Longevity: To make your design last (usually 3–7 days), avoid scrubbing the area with a loofah or towel.
• Removal: Ready for a change? Use baby oil, rubbing alcohol, or an oil-based makeup remover to gently lift the design.
• Safety Disclaimer: For external use only. Do not apply to sensitive skin, near eyes, or if you have a known allergy to adhesives. If irritation occurs, remove immediately and discontinue use. Not recommended for children under the age of 3